Looking for a Kent Moore J-22598.

[ron350]

 I have a friend that is looking for a Kent Moore J-22598 tool. This tool is used to remove the outer   sleeve on a 1968 (and others) GM tilt steering columns.

 So far nothing has showed up on ebay.

[ron350]

 I found a picture of the Kent Moore J-22598 in use and read that Kent Moore-J-22708 is a look alike tool.

[goodfellow]

Probably rare as hen's teeth, and you may have to make one.

Here's a "how to" that first suggests using two large flat blade screwdrivers, but if that fails due to heavy corrosion or rust jacking, it provides guidelines for making a simple tool using commonly available parts.

Good luck!

[ron350]

 Thanks Goodfellow i will try to make a puller using Ford battery hold down bolts.
 
 

[muddy]

Thanks Goodfellow i will try to make a puller using Ford battery hold down bolts.
 
 

If it works I would love to see it in action


Sent from my Twisted Mind Of The Mudman

[ron350]

 Wel my friend is working on a 68 Cadilliac with a tilt-telescopic steering column with side turn lights. He knows much more about tilt column's than i do but i don't think you have to remove the outer shell just to replace the turn signal switch.

[john k]

There is another tool needed to depress the locking plate on the steering column switches.  Looks similar

[jeffmoss26]

would something like this work?
https://www.hudsonlock.com/product/steering-column-lock-plate-compression-kit/

[ron350]

  Thanks but if you look closely at the pictures in post 1 & 2 you can see the tool is a puller and not a spring compressor.

I stopped by the shop today and checked out the 68 Cadillac steering column and it does not look like any column i have ever worked on  The turn signal switch is not made by Delco and it is too large to remove without removing the steel outer shell. I hope to go back friday and attempt to remove the outer shell using j-hook bolts.

[ron350]

  The battery holddown hooks did not work on this steering column because it was a telescoping column.
 When you try to use a balancer puller and the bolts the columns center shaft will just push down into the column.
This is why the service manual shows Kent Moore tool J-22598 attached to a slide hammer.