« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: My first foray into taps and dies  (Read 4895 times)

Offline bmwrd0

  • Hero Member
  • *****
  • Posts: 608
Re: My first foray into taps and dies
« Reply #15 on: June 02, 2019, 07:21:08 PM »
Getting it square is the most important part. If you have a drill press that is a good way to start threading.

But, this should also get you started.
Logged

Offline hickory n Steel

  • Hero Member
  • *****
  • Posts: 3310
Re: My first foray into taps and dies
« Reply #16 on: June 02, 2019, 07:28:25 PM »
Quote from: bmwrd0 on June 02, 2019, 07:21:08 PM
Getting it square is the most important part. If you have a drill press that is a good way to start threading.

But, this should also get you started.

Thanks, I downloaded that to my phone.
Logged
Always lookin' to learn
Pages: 1 [2]  All   Go Up
« previous next »