VEHICLES > Bikes/Trikes/Choppers/Scooters & etc.
Harley Fork Upgrade.
muddy:
Last ride I took I noticed oil residue all over the tank, engine and frame of the bike. At first I thought it was slobber out of the breathers of the engine. However it's never done this before. So looking further i saw oil drips and runs on the front fender. So i felt up and the fork was leaking.
After seeing you have to disassemble it all anyway I decided to go with an upgrade and get Progressive Monotube Cartridges.
First drain the forks. To prevent a mess later.... ask me how I know.
Once off the bike you can put them in a vice. *Helpful tip if your clamping on delicate chrome, use a old inner tube to keep from damaging the chrome.
First you take out the bottom bolt. Then you can use the lower tube as a slide hammer to knock out the top bushing and seal. (I forgot the bolt and ended up wondering why I was getting nowhere and also cutting my finger (yes that finger) )
Next take the top slider cap off. (Keep in mind this is under slight pressure from the spring) then you can pull all the old parts out. Some of these parts will get reused with the new kit.
Sent from my Twisted Mind Of The Mudman
muddy:
After cleaning everything up time for reassembly We'll start with the lower slide bushing. As can be seen mine were in need of replacing.
The cartridge goes in next being sure to refuse your old top out spring (little one at the bottom). Progressive recommendation is one preload shim. From what I was reading on forums bigger guys like myself went with two and were happy with it. So I'm going with two.
I didn't get a picture but you will also reuse your old bottom cap on the bottom of the cartridge rod. Then you can slide the bottom tube on and tighten the bolt to spec. (Add a little red loctite to these bolts)
Now time to install the top bushing, washer and seal. This can be done with a properly sized PVC pipe but for $12 I bought the correct 41mm driver.
Now once I get my oil and can fill the fork with the 5oz of 10 wt. And torque the top cap to spec. This is different then the factory spec. They'll be ready to go back on the bike. Think I'm going to polish them before that happens.
Unlike the factory setup the oil used with the Monotube kits is just for lubrication. The factory setup uses oil as a dampening agent. The difference in weight will change the rate of absorption and rebound.
The kit came with stickers. Don't forget to put them on your bike so everyone knows you have a race bike!
Sent from my Twisted Mind Of The Mudman
muddy:
While doing this job I was a little disappointed at the service provided by my local dealership. I've had it in for service at least once a year while in for inspection. But the blackness and smell of the oil it has never been changed before. I would think that should be something on their list to do with all the mileage service plans they have.
Sent from my Twisted Mind Of The Mudman
skfarmer:
thanks for the pics and story.
i know nothing of rebuilding shocks on bikes.
muddy:
--- Quote from: skfarmer on August 27, 2023, 09:50:29 PM ---thanks for the pics and story.
i know nothing of rebuilding shocks on bikes.
--- End quote ---
I knew enough to be dangerous..... the rest I watched you tube :))
Sent from my Twisted Mind Of The Mudman
Navigation
[0] Message Index
[#] Next page
Go to full version