TOOLS AND THE SHOP > WELDING & METAL FABRICATION
Bending some stainless for my bench top.
DeadNutz:
I agree with UB and they can shear it to length and width also. You won't get a sharp bend and you won't be happy with a large radius on the bends.
ScoutDriver:
I'll agree with posters above to cut the sheets to fit and trim the corners with angle steel. Stainless can be tough to bend even with a brake.
The angle steel will be replaceable if need be.
Scott
Uncle Buck:
When I had my tops bent up I had them bent to length and width and also had them bent with 2" rolled edges and welded at the corners. The extra was worth it.
walrus:
Finally took SS sht metal in to be sheared and bent, they called its done. 60 bucks to get 2 pieces sheared and then 2 bends on each piece. Hopefully they fit ;D Get them tomorrow I hope
slip knot:
cheap enough. you are gonna post some pics right ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version