TOOLS AND THE SHOP > MACHINE SHOP

BlowFish blank machined

(1/1)

pep:
Last two holes were drilled for tap size #3, 1/4 28. Is undersized for the bolt to pass thru the top half when cut.

Other than cutting, shaping, and opening the bolt pass-thru holes . It's well on it way to being a viable part.

pep:
Needs 2 locater pins and it will be done.  Holes are 1/2, going next size up  & turn for an interference fit. Hot and cold part assembly.

pep:
Turned the pins cut and set next tight tolerances. Will use one part in the freezer, the other boiling water, and assemble.

Navigation

[0] Message Index