"A Well moderated board that is a benevolent dictatorship, not a democracy" In business since June 16, 2010
Thanks Bonneyman!The Titan if yours is like this one is surprising. I have also seen it as a bit driver.How do you like the Chapman?
Hickory the ratchet is a little coarse but pretty much bullet proof. Wright still makes an open gear as well. The idea is in harsh service they can be cleaned easily and without taking them apart.I like having it but I don't think it would be a go to for me.
Got it. My reply was an attempt at Don humor. My daughter says my efforts are usually lame.-Don
If you're using the Chapman-supplied bits they aren't have bad. Not fine tooth at all - that would be the one improvement they could make.
Makes perfect sense , just hose it out with some wd40 and an air compressor and it's good to go.
Quote from: bonneyman on October 19, 2018, 03:39:09 PMIf you're using the Chapman-supplied bits they aren't have bad. Not fine tooth at all - that would be the one improvement they could make.Will it work with other bits?
SK seems quite taken with the Chapmans.I have a set of Craftsmans like yours. Have some others I'll post up.Thanks for the pix.
And my assortment of small format rats compared to an S-K 1/4"er. Really like the Reverse Gear! Short, offset, reversible, fine tooth. Mine's a Husky but I'm sure that R.G. made them for other companies.