Garage Gazette
TOOLS AND THE SHOP => MACHINE SHOP => Topic started by: pep on January 23, 2022, 01:26:26 PM
-
Last two holes were drilled for tap size #3, 1/4 28. Is undersized for the bolt to pass thru the top half when cut.
Other than cutting, shaping, and opening the bolt pass-thru holes . It's well on it way to being a viable part.
-
Needs 2 locater pins and it will be done. Holes are 1/2, going next size up & turn for an interference fit. Hot and cold part assembly.
-
Turned the pins cut and set next tight tolerances. Will use one part in the freezer, the other boiling water, and assemble.